OUR PRODUCTS
ABOUT US
CONTACT US
Add: Rm410, Shengli Square, Fushou Street,
Weifang, China
Tel: +86-536-8987558
Fax: +86-536-8987559
E-mail: info@dekenag.com
Web: www.dekenag.com
Powered by:www.300.cn 鲁ICP备18020688号
How to keep the idle irrigation equipment
How to keep the idle irrigation equipment
Author:Dekenag Alice
If the drainage irrigation equipment is not properly maintained and managed, it is extremely easy to rust and damage and cannot be used. Therefore, proper maintenance and management should be ensured after the drainage irrigation equipment is stopped.
1. After the diesel engine is stopped, all parts shall be checked and repaired thoroughly to keep them in good condition, and then the lubricating oil shall be applied. To the body of the paint, paint to be repainted to prevent rust. After inspection and maintenance to be in the room mat height, off the ground storage.
2. The motor used in the well should be removed from the well and put in the room for inspection and maintenance. Clean the dirt on the cover, check and repair the core carefully, and put it into storage. The motor and starter should be dustproof, moisture-proof and rainproof. After packing, put into storage and keep properly.
3. After the centrifugal pump is used, the pump and hose shall be removed from the well. After the clean water is released, the wear degree of the pump impeller, bearing, cup and other parts shall be checked. The bearing shall be cleaned with petrol, butter and well installed, rust on the cast iron parts such as the bottom valve of the pump and the bend pipe shall be cleaned with wire brush, and butter shall be applied, and shall be placed in the dry storeroom and stored away from the ground.
4. After the deep well pump is stopped, it should be started every 7 to 10 days, usually around 30 minutes, in case of rust at the rotating part. If it takes a long time to stop working, the pump should be taken out of the well and put into storage after maintenance.
5. When all the pipes are stopped, put the water away. The iron pipe should be painted; Do not contact the rubber pipe with gasoline; The plastic pipe should also be rinsed and placed in a dry warehouse for proper storage.